Connect a fully charged battery to the ESC.Connect the ESC receiver lead to CH2 on your receiver.Mount the ESC and motor in the vehicle.The quick start setup guide will get you running quickly using the ESC’s default settings. Motor manual: Dynamite | Horizon Hobby RC Batteries and Accessories One thing to note: The motor spec says to use a 30Amp ESC and the ESC is a 25Amp model.ĮSC manual: Dynamite | Horizon Hobby RC Batteries and Accessories put your main code here, to run repeatedly: put your setup code here, to run once: Then Ive been running this to test the motor plugging in various number in to test. Serial.println("Sending minimum output") Serial.println("Now writing maximum output.") Serial.println("Now sending Neutral signal") Serial.println("This program will calibrate the ESC.") Any ideas of why this isn't working? Please help! Thanks! #include Here is the program I've been running and using the serial monitor to change what I'm sending to the ESC at the appropriate time. I have attached my ESC calibration rules which I have followed and seem to have done except for the last part where the motor is supposed to run at the end of the set up. I've had it run forward but with not very good speed control just full speed and a bit less than full speed but not both forward and backwards. ![]() I have been trying to calibrate my esc to run my brushless motor with little success.
0 Comments
Leave a Reply. |